Brodit sup./char. Zebra TC15 Allume - 3A-avec boot

Prix 118,95 €

En stock

Livraison rapide
Produits de haute qualité
Paiements sécurisé

Détails

Plus d'infos

Compatibility

Instruction

Détails

Active holder with cig-plug

With tilt swivel. 3A charging. 12/24V. With Easy-switching system. Charging via pogo pins. Fits device with Zebra Original Rugged Boot.

The active holder charges your battery when it is in the holder. The charging device connects to the unit automatically when you put the unit in the holder. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Connects to the vehicle's cigarette lighter socket, 12/24 Volt.

Easy-switching system:

The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

Plus d'infos

Plus d'infos
Marque d'accessoire	Brodit
Barcode	7320287123555
Prix Public TTC	118,95 €
Appareil avec ou sans étui	ja
Caractéristique du support	Toestelspecifiek
Cable / Qi / charger type / connnector	Molex, sig plug, piggy tail (Easy Switching)
Charger l'appareil via	Pogo / Pins
Tension	12V et 24V compatible
Voltage (output)	5.4V
Max Amperage	3,0 Amp
Montage standaard	AMPS
Verrouillable	non
Color	zwart
Info produit	Support professionnel avec rotule pour votre smartphone, système de navigation ou tablet. Plus de réflexions ennuyeuses par la possibilité de modifier l’inclinaison.
Item Returns	This item can be returned

Voir plus + Montrer moins -

Compatibility

Voir plus + Montrer moins -

Instruction

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.